Wel-Bilt 24288 User Manual

B E N C H G R I N D E R USER’S MANUAL WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Fail

Page of 13 10 DIAGRAM & PARTS LIST • Item#s 24288, 24289 and 24290 share the same parts drawing as below:

Page of 13 11

Page of 13 12 • For Item# 24288, the lamp illustration is below:

Page of 13 13 Distributed by: Northern Tool + Equipment Co., Inc. Burnsville, Minnesota 55306-6936 NorthernTool.com Made in China

Page of 13 2 Thank you very much for choosing a Wel-Bilt™ product. For future reference, please complete the owner’s record below: Mod

Page of 13 3 • Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control, so visitors should remai

Page of 13 4 • Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. • D

Page of 13 5 UNPACKING When unpacking the Bench Grinder, please check if any parts are missing or broken, please call the distributor. Carefully

Page of 13 6 ASSEMBLY SWITCH The switch is located on the front of the grinder near the bottom. To turn the tool ON, depress the rocker switch at t

Page of 13 7 INSTALLING THE EYE SHIELDS Turn off and unplug the bench grinder. Remove all remaining parts from the plastic bag. NOTE: There is a l

Page of 13 8 OPERATION Note: The bench grinder needs to be bolted to the work surface before you start to use the tool. Use 2/5in. (10mm) bolts or

Page of 13 9 • Assemble as shown in Fig. 5. The nut should be tightened to a recommended 55 in/pds of torque. Note the orientation of the flange